NCR S26 Manual De Usuario
System Error Messages
B-4
Error Messages
System Error Messages
A system error message indicates a problem with the computer itself. A
message of this type normally appears during the power-on self-test, before
the operating system prompt appears.
message of this type normally appears during the power-on self-test, before
the operating system prompt appears.
The table below lists system error messages and the corresponding corrective
measures.
measures.
Table B-1. Error Messages
Message
Action
CMOS battery error
Replace the RTC chip or contact your dealer.
CMOS checksum error
Check the RTC chip and the necessary jumper.
If the battery is still good, run Setup.
If the battery is still good, run Setup.
Display card mismatch
Run Setup.
Diskette drive controller error
or not installed
or not installed
Check the control cable to the diskette controller.
Diskette drive error
Diskette may be bad. If not, replace the diskette
drive or cable.
drive or cable.
Diskette drive A type
mismatch
mismatch
Run Setup and select the proper drive type.
Diskette drive B type
mismatch
mismatch
Run Setup and select the proper drive type.
Equipment configuration error
Modify the memory configuration to agree with
one of the options in the memory configuration
shown in Table 2-2.
one of the options in the memory configuration
shown in Table 2-2.
Hard disk controller error
Run Setup.
Hard disk 0 error
Check all cable connections. Replace hard disk.
Hard disk 1 error
Check all cable connections. Replace hard disk.
Keyboard error or no
keyboard connected
keyboard connected
Check and connect the keyboard to the system
unit.
unit.
Keyboard interface error
Replace the keyboard or contact your dealer.