Apple Mac mini Manual De Usuario

Mac mini (Mid 2010) Take Apart — General Information 

2010-08-03

The following tools are required to service the computer:
•  ESD wriststrap and mat
•  Torx T6, magnetized
•  Torx T8, magnetized
•  Torx T9, magnetized
•  Hex 2mm (or 5/64-inch) wrench
•  #0 Phillips screwdriver
•  Logic board removal tool (922-9588)   

Important: This is a required tool to service the Mac mini (Mid 2010)

•  Tweezers (optional)
•  Black stick (922-5065), or other non-conductive nylon or plastic tool
•  Soft cloth (to protect removed parts from scratches)
•  Isopropyl alcohol and cleaning cloth (if needed)
•  Scissors or razor knife to cut tape to size (if needed)
•  Screw tray

Note: The logic board removal tool is required to dislodge the logic board assembly. Dislodging 
or removing the logic board assembly is required to access many parts (see the 

 heading).

Refer to Knowledge Base article “Hand Tools for Desktop and Portable Repairs--AP/CA/EU/JP/
LA/US” to purchase tools:

Cosmetic surfaces have a high exposure to potential damage or scratching, due to the method 
of working on the Mac mini (Mid 2010). Be extremely careful not to damage the housing and 
other cosmetic surfaces with inadvertent tool movements, or to damage the cosmetic Mylar on 
the top hard drive when removing or installing. In general, avoid scratching interior or exterior 
surfaces, and avoid leaving fingerprints. 

When there are no replacement steps listed, replace parts in the exact reverse order of the 
Removal procedure.

Important: Do not overtighten screws. Install all screws by hand. Do not use power tools.