Cisco Systems ONS 15540 Manual De Usuario
2-3
Optical Transport Turn-Up and Test Guide
78-14964-01
Chapter 2 Quick Installation Procedures
Installing Cisco ONS 15540 ESP Hardware
Perform the following procedure to install the processor card in the Cisco ONS 15540 ESP.
Step 1
Insert the processor card carefully into chassis slot 6. Guide the upper and lower edges of the
motherboard or processor card in the tracks until its connectors come into contact with the backplane.
motherboard or processor card in the tracks until its connectors come into contact with the backplane.
Step 2
Use your thumb and forefinger of each hand to simultaneously push the motherboard or processor card
in until it is fully seated in the backplane connector.
in until it is fully seated in the backplane connector.
Step 3
Use a 3/16-inch flat-blade screwdriver to tighten the captive installation screws.
Step 4
If not installing a redundant processor card, insert a blank card into slot 7.
lists the LEDs on the processor card faceplate, their default conditions, and what the
conditions indicate.
Table 2-1
Processor Card LEDs
LED
Status
Description
Status
Red
A board resets or initially powers on.
Orange
System initialization.
Green
Full initialization and operational.
Active
Green
This board is the primary processor and is running IOS software.
Standby
Green
This board is the secondary processor.
Slot 0
Green
Flash PC Card is present.
Slot 1
Green
Flash PC Card is present.
NME
1
Full Duplex
Green
Full duplex is running.
Off
Half duplex is running.
100 Mbps
Green
Operating at 100 Mbps.
Off
Operating at 10 Mbps.
Link
Green
Link is up.
Off
Link is down.
ASE
2
Full Duplex
Green
Full duplex is running.
Off
Half duplex is running.
100 Mbps
Green
Operating at 100 Mbps.
Off
Operating at 10 Mbps.
Link
Green
Link is up.
Off
Link is down.
Critical Alarm
Yellow
A critical alarm condition exists.
Major Alarm
Yellow
A major alarm condition exists.
Minor Alarm
Yellow
A minor alarm condition exists.