Toshiba Satellite R10 Manual De Usuario

4 

Replacement Procedures 

The following describes the procedure for removing the LCD harness holder. (See Figure 
4-26.) 

1.   Disconnecting the USB harness from the connector CN4612 on the system board 

and from CN4612  on the CN board, turn up the insulator and pull out the USB 
harness from  the guide of LCD harness holder. 

2.   Disconnect the LCD harness from the connector CN5501  on the system board 

and pull out  the LCD harness from  the LCD harness holder. 

3.   Disconnecting  the CN board harness from the connector CN9512 on the system 

board and from the connector CN9520 on the CN board, pull out the CN board 
harness from  the guide of LCD harness holder. 

4.   Disconnecting  the QI board cable  from  the connector CN9521 on the CN board 

and from  the connector CN9530 on the QI board, pull out the QI board cable from 
the guide of LCD harness holder. 

5.   Remove the following  screws  securing and remove the LCD harness holder. 

? 

M2.0x6.0B  

FLAT BIND screw 

 

 

 

 

x2