Bretford EPM Manual De Usuario
LAPTOP 16H
The LAP16H is specifically designed for the storage and recharging of up to laptops. To assemble/configure your new
charging trolley, simply follow the steps below...
charging trolley, simply follow the steps below...
Step 1: Open the rear doors to reveal 16 power pack shelves and the IEC power strip.
As shown on page 1.
As shown on page 1.
Ventilation:
All vents MUST be kept clear at all times, no posters etc. covering the perforations.
Also ensure there is a minimum of 50mm clearance between the back and sides of the
cabinet to ensure good air flow.
All vents MUST be kept clear at all times, no posters etc. covering the perforations.
Also ensure there is a minimum of 50mm clearance between the back and sides of the
cabinet to ensure good air flow.
Fans
If fans are fitted: Whilst charging, if the temperature in the cabinet exceeds 30° the fans will
automatically initiate. The fan guards MUST be kept clear at all times, including allowing a
minimum of 75mm clearance between the back of the cabinet and the wall to ensure good
air flow. The fans will continue to run until the temperature drops below 30°.
However, if the room has a high ambient temperature this may cause the fans to remain on.
If fans are fitted: Whilst charging, if the temperature in the cabinet exceeds 30° the fans will
automatically initiate. The fan guards MUST be kept clear at all times, including allowing a
minimum of 75mm clearance between the back of the cabinet and the wall to ensure good
air flow. The fans will continue to run until the temperature drops below 30°.
However, if the room has a high ambient temperature this may cause the fans to remain on.
Step 2: Remove the mains/3pin plug lead (if fitted) from the laptop power pack and
store in a safe place.
store in a safe place.
DO NOT CONNECT TO THE MAINS SUPPLY UNTIL STEPS 1-10 ARE COMPLETE
Step 3: All LAP16H models are supplied with 16 x IEC to
figure of eight & 16 x IEC to cloverleaf cables to be connected into the
laptop power pack & the IEC power strips. Firstly select the leads with
corresponding connector for the power packs being used in the cart.
figure of eight & 16 x IEC to cloverleaf cables to be connected into the
laptop power pack & the IEC power strips. Firstly select the leads with
corresponding connector for the power packs being used in the cart.
Step 4: Connect an IEC connector into the top IEC power strip. Continue this action
until all 16 IEC leads are connected.
until all 16 IEC leads are connected.
Step 5: Starting with the top IEC lead plug the connector in to the laptops power pack.
2
IEC
Clover leaf
Figure of eight