Intermec SR60 Manual De Usuario

Scan the SET bar code on page 51.

Scan the Set Suffix bar code.

Using the list of bar codes that starts on page 154, scan the 
four digits corresponding to the hex values you chose in 

 

Step 2.

For this example, you would scan 0, A, 0, and D. 

Scan the END bar code.

You have added a two-character suffix to all bar code data, 
regardless of label symbology, that will be added to the label data 
before it is sent to the host. 

Note: Successful programming requires four digits for the 
label ID.

Note: If you make a mistake or lose your place while setting 
this option, scan the END bar code to exit Programming 
mode. The scanner sounds a two-beep error tone to indicate 
that programming was incomplete, and the setting remains as 
it was before entering Programming mode.

Use the ASCII chart on page 158 to identify the ASCII character(s) and the 
corresponding hex code(s) for the suffix. Then use the bar codes on page 154 
to scan the four digits corresponding to the hex values.