Motorola APCO25 Manual De Usuario

• Turn the scanner OFF before disconnecting the power.

• Always write down the programmed frequencies in the event of memory loss.

• If memory is lost, simply reprogram each channel. 

The display shows 000.0000 in all channels when there has been a memory loss.

• Always press each button firmly until you hear the entry tone for that key entry, unless you

have turned 

2:OFF the 

3:KEY BEEP in the menu system.

• Do not use the scanner in high-moisture environments such as the kitchen or bathroom.

• Avoid placing the unit in direct sunlight or near heating 

elements or vents.

• If the scanner receives strong interference or electrical noise, move it or its antenna away

from the source of the noise. If possible, a higher elevation, may provide better reception.

• Disconnect the power to the unit before cleaning.

• Clean the outside of the scanner with a mild detergent. 

To prevent scratches, do not use abrasive cleaners or solvents. Be careful not to rub the
LCD window.

• Do not use excessive amounts of water.

• Do not attempt any repair. The scanner contains no user serviceable parts. Contact the

Uniden Customer Service Center or take it to a qualified repair technician.

• All radios can receive birdies (undesired signals). If your scanner stops during Scan mode

and no sound is heard, it may be receiving a birdie. Birdies are internally generated sig-
nals inherent in the electronics of the receiver.

Press L/O to lockout the channel, and then press RSM to resume scanning.

57