Brocade Communications Systems DCX 8510-4 Manual De Usuario

Control processor blade (CP8) removal and replacement

5

2010/06/18-14:56:50, [SULB-1002], 910, SLOT 7 | CHASSIS, INFO, Brocade_DCX, 

Firmwaredownload command has completed successfully.

NOTE

The time stamp on the co-cpu may not be in sync with the main cpu on the blade. This is not a 
cause for concern.

8. Log back in to the standby CP blade and type firmwareDownloadStatus on the standby CP 

blade to validate a successful commit. This may take 10 minutes.

9. If you are upgrading through several levels of the Fabric OS, repeat step 5 through step 8 as 

often as necessary based on the path outlined in the table above. Otherwise, proceed to step 
10.

10. Log out of the standby CP blade and log in to the active CP blade.

11. Proceed to 

Completing the replacement

Complete the following steps to complete the CP8 control blade replacement procedure.

1. Type haEnable to re-enable HA on the active CP blade.

NOTE

For Fabric OS 6.3.0 and later, haEnable will cause the standby CP blade to reboot. Wait until 
POST completes before moving to the next step. POST is complete when the Status LED on the 
CP blade returns to a steady green state.

2. Type haShow and verify that the command output includes “HA Enabled, Heartbeat Up”. If it is 

not yet enabled, re-enter the command until you have verified that redundancy is achieved.

DCX_124:admin> hashow

Local CP (Slot 7, CP1) : Active

Remote CP (Slot 6, CP0) : Standby, Healthy

HA Enabled, Heartbeat Up, HA State Synchronized

3. Type firmwareShow to verify that the firmware version has been updated and that the versions 

are the same on the two CP blades. The slot numbers will be different for the DCX 8510-4 or 
DCX-4S. (not all slot numbers are shown)

DCX_8510:admin> firmwareshow

Slot Name    Appl     Primary/Secondary Versions  Status

-----------------------------------------------------------

  4  FX8-24  FOS      v7.0.0

                      v7.0.0

  6  CP0     FOS      v7.0.0 

STANDBY

                      v7.0.0

  7  CP1     FOS      v7.0.0 

ACTIVE *

                      v7.0.0

 10  FX8-24  FOS      v7.0.0

                      v7.0.0