Schneider Electric SR2MAN01 Manual De Usuario

TRANSFER Menu

68

SR2MAN01 11/2007

→ 

Procedure for transferring the application, from the smart relay to the backup 
memory:

Note: if an application is already present in the backup memory, it will be 
overwritten by the new transfer (no test is performed to check the memory is free).

Note: It is not possible to directly transfer an application created with version V2 of 
the programming software from the SR2 MEM01 memory to the smart relay if this 
latter contains version V3 firmware.
In this case, see what action you should take in the section Program incompatible 
with firmware of the module (see Application incompatible with firmware on the 
smart relay, p. 70).
For more information about the compatibility of the memory cartridges, see 
Compatibility between the memory cartridges and the version of the firmware on 
the smart relay, p. 195.

1

Insert the EEPROM cartridge (SR2 MEM02) into the slot provided.

2

Select the transfer type: 

MEMORY>ZELIO using the navigation keys    .

3

Confirm the transfer command with the 

Menu/OK key.

(Enter the password if the program is password-protected). 

4

Wait for the transfer to end.
Display:  

 > > > MEMORY then TRANSFER. OK when it is complete. 

5

Confirm again by pressing 

Menu/OK key to exit the menu.

Result: The display returns to the INPUTS-OUTPUTS screen in RUN mode and to 
the MAIN menu in STOP mode.