Panasonic W1014HM0-YI Manual De Usuario

– 78 –

Chapter 9 Other Useful Functions — Setting the time data

Retention of user bits in memory

User bit settings are automatically recorded and are retained even if the power is turned off.

Frame rate information

The relationship between frame rates, image pull-down, and time codes/user bits is as follows.

・60i：600

・60P：608

・30P：308

・24P：248

・24PN：24C

・50i：502

・50P：50A

・25P：25A

・＊＊P：＊＊9

・＊＊P：＊＊1

・＊＊P：＊＊D

・＊＊P：＊＊B

・
・

Verification information on the right-hand six digits

Fixed values

Sequence No.

24P: 0-4

Other than above: F-fixed

Media management information

Updated frame flags and valid frame flags

REC mark

Camera image mode

Example)

(During shooting)

(VFR 30PN or over 60P)

(VFR over 60P)

(VFR24PN during shooting)

(VFR25PN or over 50P)

Setting the time code

Press the <TC> button to display the TC screen.

From the time code display, select [DF] or [NDF] in [DF/NDF].

Set [DF] to advance the time code in the drop frame mode, and set [NDF] to advance it in the non-drop frame mode. Note, however, that the time
code always runs in [NDF] in the 24p (23.98P) mode.

Select [SET].

The [TC SET] screen is displayed.

Set the time code using the jog dial button.

Press the jog dial button to confirm the time code setting value.

Settable time code range

59.94P, 29.97P

00:00:00:00 to 23:59:59:29

23.98P

00:00:00:00 to 23:59:59:23

50P, 25P

00:00:00:00 to 23:59:59:24

NOTE

t If you exit the time code setting screen without pressing the jog dial button, the set values will be disabled.

Time code function during battery replacement

Even during battery replacement, the backup mechanism functions, allowing the time code generator to continue operating.
When each item of the system mode has been changed, the time code of free run may shift. Turn on the power again, check the time code, and reset it,
if necessary.

Time codes in variable frame rate

In 24PN, recording is 24 frames, output is 30 frames, which matches 2:3 pull-down images.

The advance rate of the recording and output time code matches real time only when the image frame rate is 24P. When 60P, recording advance rate
is 60/24 times. In this case, the camera switches to [REC RUN] fixed operation and the time code value that is output when recording starts matches
the recording time code.

It is the same when shooting in modes other than 30P when in 30PN and shooting in modes other than 25P when in 25PN.

Externally locking the time code

The internal time code generator of the camera can be locked to an external generator.

Example of connections for external locking

As shown in the figure, connect both the reference video signal and the reference time code.