Cisco Systems ASA 5580 Manual De Usuario

Descargar
Página de 712
 
31-10
Cisco ASA Series Firewall CLI Configuration Guide
 
Chapter 31      Configuring the ASA IPS Module
  Configuring the ASA IPS module
If you do not have an inside router
If you have only one inside network, then you cannot also have a separate management network. In this 
case, you can manage the ASA from the inside interface instead of the Management 0/0 interface. If you 
remove the ASA-configured name from the Management 0/0 interface, you can still configure the IPS 
IP address for that interface. Because the IPS module is essentially a separate device from the ASA, you 
can configure the IPS management address to be on the same network as the inside interface.
Note
You must remove the ASA-configured name for Management 0/0; if it is configured on the ASA, then 
the IPS address must be on the same network as the ASA, and that excludes any networks already 
configured on other ASA interfaces. If the name is not configured, then the IPS address can be on any 
network, for example, the ASA inside network.
ASA 5505
The ASA 5505 does not have a dedicated management interface. You must use an ASA VLAN to access 
an internal management IP address over the backplane. Connect the management PC to one of the 
following ports: Ethernet 0/1 through 0/7, which are assigned to VLAN 1.
What to Do Next
(ASA 5510 and higher) Configure basic network settings. See th
(ASA 5505) Configure management interface settings. See the 
Internet
Management PC
Layer 2
Switch
ASA
Inside
Management 0/0
(IPS only)
Outside
IPS
IPS Default Gateway
Proxy or DNS Server
(for example)
334669
Security
Services
Card Slot
1
2
POWER
48VDC
POWER over ETHERNET
 6
5
4
3
2
1
0
Console
RESET
Ports 1 − 7 VLAN 1 
Default ASA IP: 192.168.1.1/IPS IP: 192.168.1.2 
Default IPS Gateway: 192.168.1.1 (ASA)
ASA 5505
Management PC
(IP Address from DHCP)
Cisco ASA SSC-05
STATUS