Cisco Systems XR 12000 SIP-601 Manual De Usuario
Configuring Serial Interfaces on Cisco IOS XR Software
Information About Serial Interfaces
HC-117
Cisco IOS XR Interface and Hardware Component Configuration Guide
High Level Over-View: Serial Interface Configuration on Clear-Channel SPAs
provides a high-level overview of the tasks required to configure a T3 serial interface on a
2-Port and 4-Port Clear Channel T3/E3 SPA.
provides a high-level overview of the tasks required to configure an E3 serial interface on a
2-Port and 4-Port Clear Channel T3/E3 SPA.
Table 10
Overview: Configuring a T3 Serial Interface on a Clear Channel SPA
Step
Task
Module
Section
1.
Use the hw-module subslot
command to set serial mode for the
SPA to be T3, if necessary.
command to set serial mode for the
SPA to be T3, if necessary.
Note
By default, the 2-Port and
4-Port Clear Channel
T3/E3 SPA is set to run in
T3 mode.
4-Port Clear Channel
T3/E3 SPA is set to run in
T3 mode.
2.
Configure the T3 controller
3.
Configure the serial interface that is
associated with the T3 controller
you configured in Step 2.
associated with the T3 controller
you configured in Step 2.
Table 11
Overview: Configuring an E3 Serial Interface on a Clear Channel SPA
Step
Task
Module
Section
1.
Use the hw-module subslot
command to set serial mode for the
SPA to be E3.
command to set serial mode for the
SPA to be E3.
2.
Configure the E3 controller
3.
Configure the serial interface that is
associated with the E3 controller
you configured in Step 2.
associated with the E3 controller
you configured in Step 2.