Hoshizaki FD-1001MRH(-C) Manual De Usuario
15
C. Location
CAUTION
1. This icemaker is not intended for outdoor use. Normal operating ambient
temperature should be within 45°F to 100°F (7°C to 38°C); Normal operating
water temperature should be within 45°F to 90°F (7°C to 3°C). Operation
of the icemaker, for extended periods, outside of these normal temperature
ranges may affect icemaker performance.
water temperature should be within 45°F to 90°F (7°C to 3°C). Operation
of the icemaker, for extended periods, outside of these normal temperature
ranges may affect icemaker performance.
. This icemaker will not work at sub-freezing temperatures. To prevent
damage to the water supply line, drain the icemaker if the air temperature is
going to go below 3°F (0°C). See "III.C. Preparing the Icemaker for Long
Storage."
going to go below 3°F (0°C). See "III.C. Preparing the Icemaker for Long
Storage."
For best operating results:
• The icemaker should not be located next to ovens, grills, or other high heat producing
equipment.
• The location should provide a firm and level foundation for the equipment.
• Allow 6" (15 cm) clearance at rear and sides for proper air circulation and ease of
• Allow 6" (15 cm) clearance at rear and sides for proper air circulation and ease of
maintenance and/or service should they be required. Allow 4" (61 cm) clearance at
top to allow for removal of the auger.
top to allow for removal of the auger.
D. Setup
1) If mounting the icemaker on top of a dispenser unit, first follow the dispenser unit's
setup procedure. Note that only cubelet models can be installed on a dispenser unit;
flaker models cannot be installed on a dispenser unit. If mounting the icemaker on top
of a storage bin, unpack the storage bin, and attach the 4 adjustable legs provided (bin
accessory) to the bottom of the storage bin.
flaker models cannot be installed on a dispenser unit. If mounting the icemaker on top
of a storage bin, unpack the storage bin, and attach the 4 adjustable legs provided (bin
accessory) to the bottom of the storage bin.
) Position the dispenser unit/storage bin in the selected permanent location.
3) Place the icemaker on top of the dispenser unit/storage bin.
4) Secure the icemaker to the dispenser unit/
3) Place the icemaker on top of the dispenser unit/storage bin.
4) Secure the icemaker to the dispenser unit/
storage bin using the mounting brackets
and the bolts provided. See Fig. .
and the bolts provided. See Fig. .
5) Level the icemaker and dispenser unit/
storage bin in both the left-to-right and
front-to-rear directions. If using a storage
bin, adjust the storage bin legs to make the
icemaker level.
front-to-rear directions. If using a storage
bin, adjust the storage bin legs to make the
icemaker level.
6) Replace the panels in their correct
positions.
Fig. 2
Bolts
Mounting
Brackets
Brackets
Icemaker
Storage Bin