HP (Hewlett-Packard) A3312A Manual De Usuario
Troubleshooting & Diagnostics
Diagnostic Information
88
Troubleshooting
Code
Description
A9h
Failure in data loopback test between buffer controller and DAT formatting ASIC.
Data header was not set correctly. HARDWARE ERROR.
Data header was not set correctly. HARDWARE ERROR.
AAh
Failure in data loopback test between buffer controller and DAT formatting ASIC.
Checksum register was not as expected. HARDWARE ERROR.
Checksum register was not as expected. HARDWARE ERROR.
ABh
Drum motor took too long to reach speed. HARDWARE ERROR.
ACh
Capstan motor took too long to reach speed. HARDWARE ERROR.
ADh
Supply-reel motor took too long to reach speed. HARDWARE ERROR.
AEh
Take-up reel motor took too long to reach speed. HARDWARE ERROR.
B1h
Status report from servo processor to main processor not valid. HARDWARE
ERROR.
ERROR.
B3h
Illegal diagnostic requested. ABORTED COMMAND.
B4h
Illegal loopcount value specified. ABORTED COMMAND.
B5h
Diagnostic needs a tape; no tape detected. ABORTED COMMAND.
B6h
Tape in drive; can only perform diagnostic when no tape present. ABORTED
COMMAND.
COMMAND.
B7h
Diagnostic not supported by drive. ABORTED COMMAND.
B8h
Reel failed to turn during reel-motor calibration.
B9h
Reel failed to stop during reel-motor calibration.
BAh
Failure to change state within time-out period. HARDWARE ERROR.
BBh
Drive failed to achieve ATF lock during Drum PG autocalibration.
BCh
Having achieved ATF lock during Drum PG autocalibration, drive could not find a
delay that would cause it to unlock again.
delay that would cause it to unlock again.
BDh
Results of drum autocalibration unacceptable; tolerance window not the right size.
BEh
Servo firmware revision incompatible with controller firmware revision.
C0h
Group found which does not comply with DDS format. MEDIUM ERROR.
C1h
DOS format violation in EOD frames.
C2h
Reference or system area DDS format violation.
C3h
No sub-data available for the group. MEDIUM ERROR.
C4h
EOD found when trying to find correct position to append data. MEDIUM ERROR.
C5h
Unreadable sub-data encountered when track-following. MEDIUM ERROR.
C6h
Tape position possibly beyond EOD. MEDIUM ERROR.
C7h
Drive action did not occur within time-out period. HARDWARE ERROR.
C8h
EOM and BOM reported simultaneously. MEDIUM ERROR.
C9h
Tape speed wrong while writing. HARDWARE ERROR.
CAh
EOD encountered; not necessarily an error condition. BLANK CHECK reported,
with Additional Sense of 0005h (EOD detected).
with Additional Sense of 0005h (EOD detected).
CBh
BOM encountered; not necessarily an error condition.
CCh
Drive reached EOM. MEDIUM ERROR.