GTO GTO Manual De Usuario
2
W i r e l e s s E x i t S e n s o r
Above is a typical location where installing a conventional
“wired” exit sensor would require cutting and trenching
across more than 50 feet of asphalt driveway.
“wired” exit sensor would require cutting and trenching
across more than 50 feet of asphalt driveway.
Gate Opener
Receiver
Driveway
Transmitter
100’ Max
Wireless
RANGE:
12 ft. radius
(max)
SENSOR:
2 feet from
driveway (max)
and 12” deep
Open Gate
Outside
Sensor Range
25 ft. from
gate (min)
Sensor and Module Placement Overview
• Determine the optimum location for the VEHICLE SENSOR using the information found above in “Sensor and
Transmitter Placement Overview”. Then dig a hole approximately 10 - 12 inches deep and 24 inches long within
2 feet and parallel to the edge of the driveway. Next, dig a trench no more than 15 ft from this hole to the location
where you will install the transmitter module. Keep the VEHICLE SENSOR and the cable uncovered at this time.
Transmitter Placement Overview”. Then dig a hole approximately 10 - 12 inches deep and 24 inches long within
2 feet and parallel to the edge of the driveway. Next, dig a trench no more than 15 ft from this hole to the location
where you will install the transmitter module. Keep the VEHICLE SENSOR and the cable uncovered at this time.
IMPORTANT: Clear an area 20 feet in all directions of metal tools, toys and automobiles, to prevent magnetic disturbance
during testing and installation.
Sensor Placement
Determining Sensor Location
For Optimum Performance:
• Locate the SENSOR as far as possible away from power transformers, power lines, underground
gas line, and telephone lines.
• Locate the SENSOR away from general moving traffic to prevent unwanted activation. Remember
that the SENSOR detects MAGNETIC DISTURBANCES caused by a vehicle’s mass and velocity.
• Range distance is approximate and will vary due to outside interference, type of soil, vehicle mass,
speed, etc.
• It is recommended that you run the Signal Cable inside PVC conduit to prevent accidental damage.
• Do not run Signal Cable in conduit with other wires such as AC power or other control wires.
• The SIGNAL CABLE CANNOT BE SPLICED. If you need more wire, contact the GTO Sales
gas line, and telephone lines.
• Locate the SENSOR away from general moving traffic to prevent unwanted activation. Remember
that the SENSOR detects MAGNETIC DISTURBANCES caused by a vehicle’s mass and velocity.
• Range distance is approximate and will vary due to outside interference, type of soil, vehicle mass,
speed, etc.
• It is recommended that you run the Signal Cable inside PVC conduit to prevent accidental damage.
• Do not run Signal Cable in conduit with other wires such as AC power or other control wires.
• The SIGNAL CABLE CANNOT BE SPLICED. If you need more wire, contact the GTO Sales
Department at 1-800-543-GATE (4283).
NOTE: Place the transmitter on
the same side of the driveway in
the line of sight of the receiver to
maximize the range.
the same side of the driveway in
the line of sight of the receiver to
maximize the range.