Bosch GPL2 Manual De Usuario

-5-

Use the tool, accessories, etc., in

accordance with these instructions and in

the manner intended for the particular type

of tool, taking into account the working

conditions and the work to be performed.

Use of the tool for operations different from

those intended could result in a hazardous

situation.

Service

Have your tool serviced by a qualified repair

person using only identical replacement

parts. This will ensure that the safety of the tool

is maintained.

Develop a periodic maintenance schedule

for tool. When cleaning a tool be careful not

to disassemble any portion of the tool since

internal wires may be misplaced or pinched

or may be improperly mounted. Certain

cleaning agents such as gasoline, carbon

tetrachloride, ammonia, etc. may damage

plastic parts.

The numbering of the product features shown

refers to the illustration of the tool on the

graphic page.
1 Exit opening for laser beam

2 Latch of battery lid

3 Battery lid

4 On/Off switch

5 Laser warning label

6 Tripod mount 1/4”

7 Serial number

8 Multiple-Purpose Attachment

9 Locking screw for Multi-Purpose

Attachment

10 Screw holes of Multi-Purpose

Attachment

11 Opening for strap attachment

12 Magnets

13 1/4” tripod mount on Multi-Purpose

Attachment

14 5/8” tripod mount on Multi-Purpose

Attachment

15 Laser Target*

16 Belt Pouch*

17 Laser viewing glasses*

18 Tripod*

*The accessories illustrated or described are

not included as standard delivery.

Features

Preparation

Inserting/Replacing the Battery

Alkaline batteries are recommended for

the tool.
To open the battery compartment 3, turn the

latch 2 in clockwise direction to position and

pull off the battery lid. Insert the batteries

provided.
When inserting, pay attention to the correct

polarity according to the representation on the

inside of the battery compartment.
Position the battery lid to the bottom of the

housing and then push it upward. To lock the

battery lid, turn the latch 2 in counterclockwise

direction to the position.

When the laser beams flash slowly during

operation,the batteries are low. When the

flashing begins, the tool can be operated for

approx. 8 h.
Always replace all batteries at the same time.

Only use batteries from one brand and with the

identical capacity.

Remove the batteries from

the tool when not using

it for extended periods. When storing for

extended periods, the batteries can corrode and

discharge themselves.

This tool is intended for accurate transfer of plumb point from floor to ceiling.

Intended Use

WARNING