Festool PI561438 Manual De Usuario

6

Smooth start-up: 
The smooth start-up ensures the machine starts 

up jolt-free.
Speed regulation: 

3.1

The speed controller (3.1) provides infi nitely 

variable setting between 1350 and 3550 rpm of 

the speed of the saw blade. This enables you to 

optimize the cutting speed to suit the material.

Material

Speed 

range

Solid wood (hard, soft)
Chipboards and hard fi bre boards
Laminated wood, blockboards, ve-

neered and coated boards

6

3-6

6

Plastics, fi bre-reinforced plastics, 

paper and fabric
Acrylic glass

3-5

4-5

Plaster and cement-bonded fi bre 

boards

1-3

Al

Aluminium panels and profi les up 

to 15 mm

4-6

Constant speed: 
The pre-selected speed remains constant whether 

the machine is in operation or in no load.
Temperature cut-out
To prevent overheating, the safety electronics 

switches the machine off when it reaches a critical 

motor temperature. 
Let the machine cool down for approx. 3-5 minutes 

before using it again. The machine requires less 

time to cool down if it is running with no load. 
Current limiting
Current limiting prevents permissibly high current 

consumption under extreme overload. This can 

lead to a decrease in the motor speed. The motor 

immediately restarts after the load is removed.

 The TS 75 EQ is fi tted with a riving 

knife (4.1) as standard. All saw work should, for 

safety reasons, only be carried out with the riving 

knife installed and correctly set!

4.1

4.2

The riving knife must be set so that
- the distance between riving knife and cutting 

circle (4.2) of the saw blade is 2 to 4 mm 

(measurement x), and

- the saw blade is set 2 to 4 mm above the riving 

knife (measurement y).

5.1

5.4

5.3

5.2

- Move lever (5.3) as far as it will go,
- push switch lock (5.4) up and push sawing unit 

down until it locks into place,

- loosen screw (5.1) with Allen key (5.2),
- set spacer wedge as shown in picture 4,
- tighten screw (5.1),
- put lever (5.3) back.

 Check regularly whether the saw 

blade is in good condition. Saw blades which are 

cracked or have changed shape should no longer 

be used, but changed immediately!
When selecting the saw blades it is essential that 

the following points are observed:
• Do not use saw blades made of high alloy high 

speed steel (HSS circular saws), as otherwise 

there is a great danger of kickback.

• Use only saw blades that have an outside 

diameter of 210mm.

• The bore diameter of the saw blade holder should 

be 30 mm.

• Use only saw blades with a fundamental 

thickness of max. 1.8 mm and a cutting width 

of 2.4 to 2.6 mm.