Harbor Freight Tools 97099 Manual Del Producto

Page 11

SKU 97009

For technical questions, please call 1-800-444-3353.

UNpACkING

When unpacking, check to make sure that the item is intact and undamaged. If

any parts are missing or broken, please call Harbor Freight Tools at the number shown

on the cover of this manual as soon as possible.

SET Up INSTrUCTIONS

read the ENTIrE IMpOrTANT SAFETY INFOrMATION section at the

beginning of this manual including all text under subheadings therein

before set up or use of this product.

risk of accidental starting; resulting in serious personal

injury. Turn the power Switch of the tool to its “OFF”

position and unplug the tool from its electrical outlet before

assembling or making any adjustments to the tool.

Note: For additional information regarding the parts listed in the following pages, refer

to the Assembly Diagrams near the end of this manual.

Assembly

NOTE: To assemble and locate the Bandsaw will require additional assistance

and a proper lifting device.
After the Bandsaw and its accessories are unpacked, make sure its Head is

lowered to its horizontal position.

(See Figure A.)

With a proper lifting device, raise the Bandsaw approximately six inches off the

floor surface.

(See Figure A.)

FIGUrE A

Once the Bandsaw is lifted, insert the Wheel Rod (92-4) through the two holes

located at the bottom/right side of the Stand (77S). Slide one Wheel (92-2) on

each end of the Wheel Rod. Place one Washer (92-1) on each end of the Wheel

WArNING