KUHN RIKON 10" Cabinet Saw Sliding Table Manual De Usuario

9

3. Slide the hardware toward the cast mounting 
bracket located on the saw body. Place the 
adjusting plate on top of the set screws as shown 
(A,Fig.5).

4. Tighten the lock knob slightly, leaving loose for 
adjustment.

5. Repeat procedure for rear mounting bracket.

6. Adjusting the parallel of the saw table and sliding 
table with the four set screws (A, Fig.5).

1. Locate the sliding table carriage mounting 
hardware as shown. Figure 6.

2. Slide the T-nuts bar into the side channel of the 
sliding table. Figure 7.

         

3. Attach the carriage table support arm to the 
bottom the the sliding table carriage using two 8MM 
carriage bolts, two 8MM washers and two 8MM hex 
bolts. The head of the carriage bolts should lock 
into the bottom of the sliding table carriage. Finger 
tighten the two 6MM hex bolts only until next step 
is completed. Figure 8.