Cisco Systems ASR 901 10G Manual De Usuario

The RJ-45-to-DB-25 adapter (Cisco part number 29-0810-01) can be purchased from Cisco 
Systems.

Configure the terminal or terminal emulation software for 9600 baud, 8 data bits, no parity, and 2 stop 
bits. 

Hardware flow control is not possible on the console port.

This section describes how to connect the following router interfaces:

The RJ-45 port supports standard straight-through and crossover Category 5 unshielded twisted-pair 
(UTP) cables. Cisco Systems does not supply Category 5 UTP cables; these cables are available 
commercially.

Complete the following steps to connect the cable to the router Gigabit Ethernet port:

Ensure the router is powered off.

Connect one end of the cable to the GE port on the router.

Connect the other end to the BTS patch or demarcation panel at your site.

For more information about Gigabit Ethernet connectors including pinouts, see 

Complete the following steps to connect the cable to a router T1/E1 port:

You must close the relays on the card using the standalone subcommand. For more information, see the 
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide.