Craftsman 315.24234 Manual De Usuario

14

15

This product requires assembly. 
n

  Carefully lift saw from the carton by the carrying handle 

and the saw base, and place it on a level work surface. 

 

NOTE: This saw is heavy. To avoid back injury, lift with 
your legs, not your back, and get help when needed.

n

  This saw has been shipped with the saw arm secured 

in the down position. To release the saw arm, push 
down on the top of the saw arm, cut the tie-wrap, and 
pull out on the lock pin.

n

  Lift the saw arm by the handle. Hand pressure should 

remain on the saw arm to prevent sudden rise upon 
release of the tie wrap.

n

  Inspect the tool carefully to make sure no breakage or 

damage occurred during shipping.

n

  Do not discard the packing material until you have 

carefully inspected and satisfactorily operated the tool.

n

  The saw is factory set for accurate cutting. After

assembling it, check for accuracy. If shipping has 
influenced the settings, refer to specific procedures 
explained in this manual.

n

  If any parts are damaged or missing, please call

1-800-932-3188 for assistance.

If any parts are missing, do not operate 

this tool until the missing parts are replaced. Failure 
to do so could result in possible serious personal 
injury. 

Do not attempt to modify this tool 

or create accessories not recommended for use 
with this tool. Any such alteration or modification is 
misuse and could result in a hazardous condition 
leading to possible serious personal injury.

Do not connect to power supply until 

assembly is complete. Failure to comply could result 
in accidental starting and possible serious personal 
injury.

Always make sure the compound miter 

saw is securely mounted to a workbench or an ap-
proved workstand. Failure to heed this warning can 
result in serious personal injury.

The compound miter saw should be permanently mount-
ed to a firm supporting surface such as a workbench. 
Four bolt holes have been provided in the saw base for 
this purpose. Each of the four mounting holes should be 
bolted securely using 3/8 in. machine bolts, lock washers, 
and hex nuts (not included). Bolts should be of sufficient 
length to accommodate the saw base, lock washers, hex 
nuts, and the thickness of the workbench.
Tighten all four bolts securely.
The hole pattern for mounting to a workbench is shown in 
figure 8. Carefully check the workbench after mounting to 
make sure that no movement can occur during use. If any 
tipping, sliding, or walking is noted, secure the workbench 
to the floor before operating.

Fig. 8

�

�