Chicago Electric 69231 Manual De Usuario
Page 10
For technical questions, please call 1-800-444-3353.
Item 69231
SAFETY
OPERA
TION
MAINTENANCE
SETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool to its “OFF” position, remove the Safety Lock and unplug the
tool from its electrical outlet before assembling or making any adjustments to the tool.
TO PREVENT SERIOUS INJURY:
DO NOT OPERATE WITH ANY GUARD DISABLED, DAMAGED, OR REMOVED.
Moving guards must move freely and close instantly.
Installing the Blade (blade sold separately)
1. Unthread the two Screws holding the Lower Blade Guard in place. Remove the Screws, Washers and
Lower Blade Guard.
2. Slide the Hex Wrench onto
the Hex Nut and the Slotted
Wrench onto the Spindle.
3. Hold the Spindle in place with the
Slotted Wrench while unthreading
the Hex Nut with the Hex Wrench.
4. Remove the Hex Nut, Outer
Flange and old blade (if in place).
Keep the Inner Flange in place.
5. Slide the new Blade and the
Outer Flange onto the Spindle.
6. Thread the Hex Nut onto
the Spindle and tighten in
place with the wrenches.
7. Replace the Lower Blade Guard and
secure in place with the Washers and
Screws.
Installing/Adjusting the Rip Fence
1. Place the Rip Fence on the Table
Top to the left of the Blade.
2. Pull up on the Lock Lever, slide the Rip Fence to the
desired location, then press the Lock Lever down to lock the
Rip Fence in place on the Table Top.
Figure E
Saw Blade
Spindle
Inner Flange
Outer Flange
Hex Nut
Hex Wrench
Slotted Wrench
Lower Blade Guard
Washer
Screw
Lock
Lever
Rip Fence
Miter Guide
Figure F