Cisco Systems 815 Manual De Usuario
3-7
Cisco 815 Integrated Services Router Hardware Installation Guide
OL-9558-01
Chapter 3 Troubleshooting
Problem Solving
Step 3
Press Ctrl-Z to exit configuration mode:
Router(config)# Ctrl-Z
Step 4
Reboot the router, and enter the recovered enable password.
Problem Solving
The key to problem solving is to isolate the problem to a specific subsystem by
comparing what the router is doing to what it should be doing.
comparing what the router is doing to what it should be doing.
In problem solving, consider the following subsystems of the router:
•
WICs—Refer to the LEDs on the cards and the LEDs on the router front panel
to help identify a failure. For more information on WAN interface cards
(WICs), refer to the
to help identify a failure. For more information on WAN interface cards
(WICs), refer to the
•
Cables—Check all the external cables that connect the router to the network.
•
Power system—Check the external power source, power cable, router power
supply, and circuit breaker. Check for inadequate ventilation or air
circulation that might cause overheating.
supply, and circuit breaker. Check for inadequate ventilation or air
circulation that might cause overheating.
OK LED Diagnostics
Use the front panel OK LED to determine any problems with the router. When the
router first boots up, it performs a power-on self-test (POST). If the router detects
a problem during the POST, the OK LED blinks in different patterns (described
in
router first boots up, it performs a power-on self-test (POST). If the router detects
a problem during the POST, the OK LED blinks in different patterns (described
in
), depending on the problem. A pattern consists of a specific number
of blinks that is repeated until the router is turned off. If the router experiences
any of these problems, contact your Cisco reseller.
any of these problems, contact your Cisco reseller.