Craftsman 137.21236 Manual De Usuario

12

13

12

13

1.  Thread the miter handle (1) into the hole (2) 

located at the front of the miter table.

1.  Push down slightly on the switch handle (1).

2.  Pull the hold-down latch (2) out of the long slot (5) 

of locking hole (3) and turn 90º to insert into the 

short slot (6).

3.  Pull up the switch handle (1) to raise to the up 

position.

1

2

3

1

2



!

When transporting or storing the miter saw, the 

cutting head should always be locked in the 

down position.

1.  Push the switch handle (1) down to its lowest 

position.

2.  Pull the hold-down latch (2) out of the short slot 

(6) of the locking hole (3) and turn 90º to insert 

into the long slot (5). 

     

IMPORTANT: To avoid damage, never carry 

the miter saw by the switch handle, the cutting 

arm or the miter handle.  ALWAYS use the 

designated carrying handle (4). 

1

2

3

1.   Squeeze the metal collar wings (2) of the dust 

bag (1).

2.   Place the dust bag neck opening around the 

exhaust port (3), and release the metal collar 

wings.

4

2

1

3

5

6

1.  Loosen the extension stay locking screw (1) 

under the saw base (2).

2.  Place the rear extension stay (3) into the 

holes provided in the miter saw base.  Make 

sure the angle of stay is in the down position 

(as shown in Fig. D) for maximum support.

3.  Insert the extension stay locking screw back 

to hole and tighten to hold the extension.

 

1.  Loosen the lock knob (3) from the rear side of 

the saw base (4).

2.  Place the hold-down clamp assembly (1) in 

one of the mounting holes (2).

3.  Tighten the lock knob (3).