Craftsman 137.21807 Manual De Usuario

28

29

28

29

MOVE THE TABLE SAW (FIG. CC)
1.  Slide the table extension toward 

the table until it rests against the 
saw table and tighten the two cam-
locking levers.

2.  Hold the table saw firmly, pull the 

table saw toward you until the saw 
is balanced on the wheels.

3.  Move the saw to the desired 

location for operation or store the 
saw in a dry environment.

RIP FENCE ADJUSTMENT (FIG. DD)
1.  The fence (1) is moved by lifting 

up on the handle (2) and sliding 
the fence to the desired location. 
Pushing down on the handle locks 
the fence in position.

2.  Position the fence on the right side 

of the table and along the edge 
miter gauge groove.

3.  Lock the fence handle. The fence 

should be parallel with the miter 
gauge groove.

4.  If adjustment is needed to make the 

fence parallel to the groove, do the 
following:

●  Loosen the two bolts (3) and lift 

up on the handle (2).

●  Hold the fence bracket (4) firmly 

against the front of the saw table. 
Move the fence until it is parallel 
with the miter gauge groove.

●  Push the handle down and 

tighten both bolts.

5.  If fence is loose when the handle is 

in the locked (downward) position, 
do the following:

●  Move the handle (2) upward 

and turn the adjusting nut (5) 
clockwise until the rear clamp is 
snug.

●  Over-tightening the adjusting 

bolts will cause the fence to come 
out of alignment.

1 3

2

4

5