Graco 249369 Manual De Usuario
Installation
12
311051F
Mount Gun
Reciprocating Arm Rod Mount
To mount the gun on a reciprocating arm rod [0.5 in. (13
mm) diameter maximum]:
mm) diameter maximum]:
1.
Insert the mounting bar (A) through the hole in the
manifold as shown in F
manifold as shown in F
. 5.
2.
Secure the gun to the bar by tightening the mount-
ing screw (B).
ing screw (B).
Stationary Support
To mount the gun on a stationary support (refer to F
and Mounting Hole Layout, page 35):
1.
Align the manifold with the alignment pins. Locate
alignment pins and holes per the Mounting Hole
Layout illustration, page 35.
alignment pins and holes per the Mounting Hole
Layout illustration, page 35.
2.
Secure the gun to the support with two M5 x 0.8
capscrews (C). The screws must be long enough to
engage the threaded holes in the gun manifold to a
depth of 1/4 in. (6 mm).
capscrews (C). The screws must be long enough to
engage the threaded holes in the gun manifold to a
depth of 1/4 in. (6 mm).
Retrofit Adapter Plate
The retrofit adapter plate enables the manifold to be
attached to a variety of bolt patterns.
attached to a variety of bolt patterns.
To mount the gun using the retrofit adapter plate (kit
288197):
288197):
1.
Mount adapter plate to manifold using the three
screws provided with the kit (F
screws provided with the kit (F
. 7).
2.
Bolt plate to mounting surface using four M5 x 0.8
capscrews. Refer to the Mounting Hole Layout,
page 36.
capscrews. Refer to the Mounting Hole Layout,
page 36.
Use the 1/8 in. alignment pin (P) to assist in orient-
ing the gun.
ing the gun.
F
IG
. 5: Reciprocating Arm Mount
A
B
TI8094a
P
F
IG
. 6: Stationary Support Mount
F
IG
. 7: Retrofit Adapter Plate Mount
TI8095 a
C
TI8180a