Graco 258849 Manual De Usuario

1.

Engage trigger lock and pull relief valve UP to 
release pressure.

2.

Remove material cup and properly dispose cup liner 
or excess material. 

3.

Remove and clean sprayer intake tube and screen 
with water (or flushing fluid) and a brush every time 
you flush the sprayer. Reconnect intake tube.

4.

Clean cup if not using a liner, and fill with water or 
appropriate flushing fluid.

5.

Reconnect material cup and shake sprayer to move 
clean water around and clean all areas inside of 
cup and underside of sprayer.

Failure to properly clean sprayer after each use will result 
in hardened materials, damage to the sprayer, and the 
warranty will no longer be valid.

Use only water-based materials. Do not use materials 
which state “FLAMMABLE” on the packaging. For more 
information about your material, request MSDS from dis-
tributor or retailer. 

Spraying certain materials may cause static build-up 
in the sprayer that can result in static shock to the 
user. If this occurs, first ensure the material has a flash 
point greater than 100° F (38° C) and does not state that it 
is FLAMMABLE anywhere on the package. If still feeling a 
static shock, the material likely contains a non-mineral 
spirits fluid such as, but not limited to, xylene, toluene, or 
naphtha, which can build up static. Switch to an alterna-
tive material.

Keep spray area well-ventilated. Keep a good supply of 
fresh air moving through the area.

Protect the internal parts of this sprayer from water. 
Do not submerge the sprayer in cleaning fluid. Openings 
in shroud allow cooling of mechanical parts and electron-
ics inside. If water gets into these openings, the sprayer 
could malfunction or become permanently damaged.

ti14994a

ti14999a

ti15000a

ti15002a

ti15001a

ti15441a