Graco 261800 Manual De Usuario

•

Before assembling roller, follow Priming 
instructions, beginning on page 9 for Hopper 
Method or page 12 for Immersion Method.

•

After priming, only paint should come out of 
spray gun. Water in hose line will cause paint to 
run.

1. Set AllControl to lowest 

ROLL setting.

2. If installed, remove tip and 

guard assembly from gun.

3. Make sure gasket is in 

place in bottom of roller 
frame.

4. Rest roller on flat surface 

and align gun with roller. 
Tighten nut with wrench 
while keeping gun and 
roller aligned.

5. Unlock gun trigger safety. Trig-

ger gun. Roll surface until paint 
is fully dispersed on roller. This 
may take a minute.

6. Increase pressure only if triggering gun does 

not supply enough paint for your rolling speed.

7. Whenever you stop painting, relieve pressure, 

page 7 and elevate roller end of extension tube 
to prevent paint from draining out.

8. Flush the pump, gun and pressure roller imme-

diately after each use to prevent paint from dry-
ing in the pressure roller and damaging it. See 
Shutdown and Cleaning, beginning on page 20.

ti9170a

ti9339a

ti9650a

•

Trigger gun briefly only when you need 
more paint. 

•

For best operating pressure set AllControl 
to the lowest ROLLER setting which 
provides an even paint supply to the roller. 

ti8922a