Graco 258864 Manual De Usuario
Storage
16
3A0705E
Cleaning Sprayer Exterior
•
Wipe paint off outside of sprayer using a soft cloth
moistened with water or flushing fluid.
Do NOT submerge the sprayer.
moistened with water or flushing fluid.
Do NOT submerge the sprayer.
Tips
•
Tips will require replacement depending on
abrasiveness of paint.
abrasiveness of paint.
•
Do not spray with worn tip. See Troubleshooting,
page 18.
page 18.
Storage
1.
Dilute 4 oz. bottle of Pump Armor Concentrate with
an additional 4 oz. of water in material cup.
an additional 4 oz. of water in material cup.
2.
Thread cup into sprayer, put prime/relief valve to UP
position and squeeze sprayer trigger for approxi-
mately 10 seconds.
position and squeeze sprayer trigger for approxi-
mately 10 seconds.
3.
Reverse spray tip to UNCLOG position, put
prime/relief valve DOWN to spray position, and aim
sprayer into waste area. Pull trigger for 1-2 seconds.
prime/relief valve DOWN to spray position, and aim
sprayer into waste area. Pull trigger for 1-2 seconds.
4.
Properly dispose of used Pump Armor mixture from
material cup and rinse cup with water.
material cup and rinse cup with water.
5.
Store sprayer indoors in a cool, dry place. Store in
an upright position only.
an upright position only.
NOTE: For prolonged battery life, lithium ion
batteries should be stored at half charge in an
environment below 90° F (32° C).
batteries should be stored at half charge in an
environment below 90° F (32° C).
NOTICE
Failure to store with sprayer with Pump Armor will
result in operational problems the next time you spray.
Always circulate Pump Armor through the sprayer
after cleaning. Water left in the sprayer will corrode
and damage the pump.
result in operational problems the next time you spray.
Always circulate Pump Armor through the sprayer
after cleaning. Water left in the sprayer will corrode
and damage the pump.
ti15442a
4 oz
ti15425a
ti15418a
ti14991a
ti15001a
ti15438a