Graco 311001G Manual De Usuario

1.

Engage the trigger lock. See F

2.

Shut off the pump. See your pump manual.

3.

Shut off the gun air supply.

4.

Disengage the trigger lock. See F

5.

Hold a metal part of the gun firmly to a grounded 
metal pail. Trigger the gun to relieve pressure. See 
F

. 12.

6.

Open all fluid drain valves in the system, having a 
waste container ready to catch drainage. Leave 
drain valve(s) open until you are ready to spray 
again.

7.

Engage the trigger lock. See F

8.

If you suspect the spray tip or hose is clogged or 
that pressure has not been fully relieved after follow-
ing the steps above, VERY SLOWLY loosen the tip 
guard retaining ring or hose end coupling to relieve 
pressure gradually, then loosen completely. Clear 
hose or tip obstruction.

Always engage the trigger lock when you stop spraying 
to prevent the gun from being triggered accidentally by 
hand or if dropped or bumped.

Remember, this is not an air spray gun. For your 
safety be sure to read and follow the Warnings on 
pages 4 and 5 and throughout the text of this instruc-
tion manual.

Keep the wallet sized warning card (222385), pro-
vided with the gun, with the operator of this equip-
ment at all times. The card contains important 
treatment information should an injection injury occur. 
Additional cards are available at no charge from 
Graco.

The system pressure must be manually relieved to 
prevent the system from starting or spraying acciden-
tally. Fluid under high pressure can be injected 
through the skin and cause serious injury. To reduce 
the risk of an injury from injection, splashing fluid, or 
moving parts, follow the Pressure Relief Procedure 
whenever you:
•

are instructed to relieve the pressure,

•

stop spraying,

•

check or service any of the system equipment,

•

or install or clean the spray tip.

Follow Pressure Relief Procedure on page 10 when 
you stop spraying and before cleaning, checking, ser-
vicing, or transporting equipment. Read Warnings, 
page 4.

TI6555A

TI6581A

TI6582A