Echo HCA-265 Manual De Usuario

5.  Tighten two (2) drive shaft clamp bolts (B) securely.

6.  Route throttle linkage and ignition lead assembly along shaft and 

clip as shown.

1.  Close choke and remove air filter cover.

2.  Place throttle linkage (C) through adjustment fixture (D) and install 

wire end into large carburetor throttle swivel hole (E). Check 

throttle for freedom of movement and that wide open throttle / low 

idle extremes are adjusted properly.  The throttle linkage must be 

adjusted by moving the adjustment fixture (D).  Consult with your 

Echo Dealer for correct adjustment procedure.

3.  Connect 2 ignition stop leads (F, G) from throttle cable tubing to 2 

ignition leads (F, G) on engine.

4.  Secure ignition leads against engine housing with clip (H).

5.  Install air filter and cover.

Gear Housing must be aligned properly with engine.  Aligning cen-

ter locating hole in driveshaft housing with center drive shaft bolt 

(A) provides correct alignment.