Dolmar MS-22C Manual De Usuario

Turn the machine upside down, and you can replace the nylon cutting head.

– Insert the hex wrench through the hole in the gear case and rotate the

receiver washer (3) until it is locked with the hex wrench.

– Loosen the nut (1) (left-hand thread) with the socket wrench and remove

the nut (1), and clamp washer (2).

NOTE:The clamp washer (2), and nut (1) are not necessary for mounting the

nylon cutting head. The nylon head should go on top of the receiver
washer (3).

– Screw the nylon cutting head onto the shaft.

– Make sure that the blade is the left way up.

MOUNTING OF NYLON CUTTER HEAD

Rotation

Hex wrench

Tighten

Loosen