MTD LT31CS Manual De Usuario
SECTION 3: ASSEMBLING YOUR TRIMMER
7
FIGURE 1
FIGURE 2
FIGURE 3
Decal
On some units, the J-handle may be pre-installed, requiring
only screw loosening and J-handle adjustment tailored to the
operator. Go to step 6 to adjust the J-handle if it is pre-installed.
only screw loosening and J-handle adjustment tailored to the
operator. Go to step 6 to adjust the J-handle if it is pre-installed.
INSTALLING AND ADJUSTING THE J-HANDLE
Installing
1.
Remove the screws, nuts, and top and middle clamp
pieces that were installed on the J-handle for
shipping.
pieces that were installed on the J-handle for
shipping.
2.
Place the J-handle between the top and middle
clamp pieces, Figure 1.
clamp pieces, Figure 1.
(4) Screws
Top Clamp
J-Handle
Middle Clamp
Bottom Clamp
Nuts
3.
While holding the three pieces together, install the four (4)
screws through the top clamp and into middle clamp.
screws through the top clamp and into middle clamp.
NOTE:
The holes in the top and middle clamp will line
up only when assembled correctly.
up only when assembled correctly.
4.
Place the clamps and the J-handle over the shaft
housing and onto the bottom clamp.
housing and onto the bottom clamp.
5.
Hold each hex nut in the bottom clamp recess with a
finger. Start screws with a large Phillips screwdriver.
Do not tighten until you make the handle adjustment.
finger. Start screws with a large Phillips screwdriver.
Do not tighten until you make the handle adjustment.
Adjusting
6.
Loosen the screws so that the J-handle can be
easily moved in the clamp assembly. Do not remove
the screws or nuts.
easily moved in the clamp assembly. Do not remove
the screws or nuts.
7.
Slide the J-handle in or out until the arrow/white line on
the decal touches the clamp assembly, Figure 2.
the decal touches the clamp assembly, Figure 2.
8.
While holding the unit in the operating position,
position the J-handle to the location that provides
you the best grip, Figure 3.
position the J-handle to the location that provides
you the best grip, Figure 3.
9.
Tighten the clamp screws evenly, until the J-handle
is secure.
is secure.