Hitachi CG 22EAS (SL) Manual De Usuario

16

29

30

Fig. 35

Check angle transmission or angle gear for 

grease level about every 50 hours of operation by 

removing the grease fi ller plug on the side of angle 

transmission.

If no grease can be seen on the fl anks of the gears, 

fi ll the transmission with quality lithium based 

multipurpose grease up to 3/4. Do not completely fi ll 

the transmission.

Fig. 36

(1) Remove the case (31) by fi rmly pushing inward 

the locking tabs with your thumbs as shown in 

Fig. 37.

31

Fig. 37

(2) After removing the case, take out the reel and 

discard the remaining line.

(3) Fold the new nylon line unevenly in half as shown 

in picture.

  Hook the U-shaped end of the nylon line into the 

groove (32) on the center partition of the reel.

  Wind both halves of the line on the reel in the 

same direction, keeping each half of the line on 

its own side of the partition. (Fig. 38)

32

4˝ (10 cm)

Fig. 38

(4) Push each line into the stopper holes (33), 

leaving the loose ends approx. 4˝ (10 cm) in 

length. (Fig. 39) 

33

4˝ (10 cm)

4˝

 (10 cm)

Fig. 39

(5) Insert both loose ends of the line through the cord 

guide (34) when placing the reel in the case. (Fig. 

40)

34

33

Fig. 40

  When placing a reel in the case, try to line up the 

stopper holes (33) with the cord guide (34) for 

easier line release later.

000Book_CG22EAS_US.indb   16

000Book_CG22EAS_US.indb   16

2010/01/14   9:49:39

2010/01/14   9:49:39