Thermo Products AH2-A Manual De Usuario

1

SAFETY SECTION 
 
This page contains various warnings and cautions found throughout this Service and Installation 
Manual.  Please read and comply with the statements on the cover and the statements below. 
 

cause injury or property damage.  Refer to this manual.  For assistance or additional 
information consult a qualified installer, service agency, or manufacturer listed below. 
 
 

: If drilling or screwing into panel or plate is necessary, make certain drill or screw 

does not penetrate into any part of evaporator coil or hot water coil and cause damage.  Personal 
injury and/or property damage may result. 
 
 

:  Do not use this system if any part has been under water.  Immediately call a 

qualified service agency to inspect the system and to replace any part of the electrical or control 
system which has been under water. 
 
 

:  The cooling and heating coils must be cleaned by a qualified service person. 

 
 

:  This air handler is not to be used to condition during construction. 

 
 

:  When testing electrical equipment, always follow standard electrical procedures 

and precautions. 
 
 

:  DO NOT  wet electronic components during hydronic testing.  Wetting 

electronic components may damage circuitry and cause a hazardous situation.  Dry moisture from 
all leads and terminals if wetting occurs.  Wait at least 24 hours for the circuit to fully dry before 
energizing the system. 
 
 

:  Personal injury or property damage could result from major repair or service of 

this system by anyone other than a qualified contractor. 
 
 

:  If you do not follow these instructions exactly an unsafe condition may result 

causing personal injury, loss of life or property damage.