Heath Zenith SL-7210 Manual De Usuario

2

2.  Mounting  light  on  a  solid,  vertical  surface 

(wall) using two round-head screws.

•  Determine mounting location. IMPORTANT:

•  Open  battery  com-

partment  door  and

remove batteries and

tab.  Note:  Discard

plastic tab.

•  Drill  one  1/16"  pi-

lot  hole  for  keyhole

mounting screw and

insert  screw.  Note:

Leave approximately

1/8"  (3  mm)  of  the

screw  threads  ex-

posed.

•  Using  the  keyhole

on  the  back  of  the

light,  temporarily

hang light fixture on

screw.

Keyhole Slot

Mounting Hole

3.  Mounting light on a solid, horizontal surface 

(eave) using two round-head screws.

•  Determine mounting location. IMPORTANT:

•  Follow  the  directions  for  vertical  surface

mounting  to  complete  installation.  Note: 

The light fixture will not need to be leveled

for horizontal mounting.

For best performance, mount the fixture about 8

feet (2.4 m) above the ground.
Note:

Mounting fixture higher than 8 ft. (2.4 m)

will reduce coverage distance.

1.  Mount solar panel base on a solid surface using 

three tapered screws. Adjust the panel to point

directly  at  the  noon  sun.  Avoid  obstructions

such as trees or buildings that may block sun

light. Allow for enough wire to reach the case.

You will want to re-aim the solar panel as

the seasons change to keep it pointed directly

at the noon sun.

Mounting Holes (3)

•  Level light fixture.

•  From inside the battery compartment, mark

location of second screw in the mounting

hole.

•  Remove light and drill one 1/16" pilot hole

in second location.

•  Hang light on keyhole screw and insert sec-

ond screw through mounting hole. Tighten

securely.

Detection Zone

Detection Zone

Battery 

Compartment 

Door

Battery 

Compartment 

Door