Philips LVQ-212 Prospecto

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

This is a guide created to help you how to wire the older 1991-2001 motorized headlights into the newer 2002-2005 fixed 

headlights.  Please refer to the proper instruction guides when installing the HID lights.  If you are looking for more 

conversion information, please visit our manual directory.  Other related guides include: 

 

This instruction and many others are available for download online at 

http://www.downforce.biz/manual/

 

Halogen lights run on 55 watts of continuous power.  The HID lighting system runs on 35 watts.  HID ballast start up requires 

a higher current load of 25 AMPS for the first 5-10 seconds depending on the brand of your HID system.  The factory 20 

AMP fuse is sufficient to operate the HID lights, DF does not recommend increasing the fuse load.  A properly connected 

HID system will never blow the fuse.  The factory HID on the 2002+ NSX runs on 20 AMP fuses.  If your fuses are burning 

out you need to check your wiring for a possible short or wiring that is too small.

 

• 

There are several WARNING sections in the installation.  Always read and follow the instruction to prevent 

injuries, accidents, and possible damage to the vehicle. 

• 

Always disconnect the battery’s main terminal before performing any electrical related work to prevent accidental 

injuries or damages.

 

• 

Do not power the HID ballast without a bulb, the high voltage system will arc at the socket area and possibly 

damage or hurt someone.

 

 

Rev 12/10/2007

 

 

Wire Size Recommendations 12 Volt DC 

Wire Gauge 

(AWG) 

Current 

(AMP) 

Power 

(W) 

12 30 360 
14 24 288 
16 20 240 
18 15 180 

 

 
 
 
 

 

 

  Requirements

 

   

           

            

 

 

   Wire Cutter or Stripper                Heat Shrink Tube                 Heat Gun