Woodstock M1099 Manual De Usuario

-29-

=`^li\*(% Carriage lock and feed control.

Carriage Lock 

Cap Screw

Half Nut 

Lever

Use these steps to learn how to setup your lathe for a 
power feed operation. The example in 

=`^li\*) shows 

lathe setup for a power feed rate of 0.012".  Remember,  
the carriage direction is reversed when spindle rotation is 
reversed.

(%  DISCONNECT LATHE FROM POWER!

)%  Turn the feed dials to the numeral and letter indi-

cated by the chart in

=`^li\*). 

*%  Using the chart in=`^li\*), gather the required 

change gears.

+%  Open the side cover and use a 6mm hex wrench to 

loosen the lash adjuster (

=`^li\*)) and swing the 

change gear assembly out of the way. 

,%  Remove the spindle E-clips and cap screw, lubricate, 

and swap out the change gears in the order shown 
on the chart in 

=`^li\*)% 

-%  Move the lash adjuster so the gear backlash is 

between 0.003" to 0.008", tighten the lash adjuster 
cap screw, and close the side cover. 

.%  Using a 5mm hex wrench, loosen the carriage lock 

(

=`^li\*(), and use the half nut lever to engage 

and disengage the power feed when required.

=`^li\*)% Power feed setup.

Change Gears

Feed Dials

Lash Adjuster

Feed Chart