Harbor Freight Tools 55167 Manual De Usuario

Page 11

SKU 55167

1. 

Attach the Handle (30) to the Cover (31) using screw (29) inserted from the Handle 
top-rear. Refer to the photo at the top of the next page, and the Assembly Diagram on 
page 24.

2. 

Attach  the  Cover  Locking  Spring  (8)  to  the  front  of  the  Base  Frame  (14)  using  the 
supplied Machine Screw (42), Washer (40), and Nut (41).

3. 

Attach  the  handle  to  the  Face  Shield  (38) 
by lining up the two rectangular tabs on the 
handle with the corresponding holes in the 
face shield and
1)  pressing it upwards

and then

2)  pressing it forward from the back, locking 

the round tab in place.

 

See  numbered  steps  in  illustration  to  the 
right.

When unpacking, check to make sure the following parts are included: Flux Wire Welder, 
Shade #10 Face Shield (38), Torch (1), Ground Cable (33), Wire Brush / Hammer (39), 
Power Cord (32), Wire Spool, Spare Welding Tip, and Contact Tip Wrench (43).

This unit is packed with a protective light film of oil, wipe the unit of with a clean rag prior to 
assembly.

If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover 
of this manual as soon as possible.

Handle

Face 

Shield

Round 

Tab