Chauvet 250 Manual De Usuario
Operating Instructions
Q-Wash 250 User Manual
11
2006-05-17/13:18
DMX-512 addressing
This mode enables the use of a universal DMX controller device. Each fixture requires a "start
address" from 1 to 511. A fixture requiring one or more channels for control begins to read the data
on the channel indicated by the start address. For example, a fixture that occupies or uses 6 channels
of DMX and was addressed to start on DMX channel 100, would read data from channels: 100, 101,
102, 103, 104, and 105. Choose start addresses so that the channels used do not overlap and notate
the start address selected for future reference.
If this is your first time addressing a fixture using the DMX-512 control protocol than I suggest jumping
to the Appendix Section and read the heading
address" from 1 to 511. A fixture requiring one or more channels for control begins to read the data
on the channel indicated by the start address. For example, a fixture that occupies or uses 6 channels
of DMX and was addressed to start on DMX channel 100, would read data from channels: 100, 101,
102, 103, 104, and 105. Choose start addresses so that the channels used do not overlap and notate
the start address selected for future reference.
If this is your first time addressing a fixture using the DMX-512 control protocol than I suggest jumping
to the Appendix Section and read the heading
“DMX Primer”. It contains very useful information that
will help you understand its use.
S e t t i n g t h e s t a r t i n g a d d r e s s
1. Press the [MENU] button until the display reads
“A
ddr
”
.
2. Press the [ENTER] button confirm selection.
3. Press the [Up] and [Down] buttons to increase or decrease values until the desired value is
achieved.
4. Press the [Enter] button to activate selection.
User Configurations
P a n I n v e r t & T i l t I n v e r t
It is possible to invert the pan and tilt head movement from within the fixture itself. This could be
helpful in situations where the positioning or rigging of a fixture led to a reverse orientation of the
fixture in relation to all or most other fixtures installed. When choosing to command the pan or tilt of
all fixtures at the same time you will notice that the fixtures whose orientation is different from the
others will most likely move opposite of the rest. You can apply a pan and tilt Invert by following the
settings in the table below.
helpful in situations where the positioning or rigging of a fixture led to a reverse orientation of the
fixture in relation to all or most other fixtures installed. When choosing to command the pan or tilt of
all fixtures at the same time you will notice that the fixtures whose orientation is different from the
others will most likely move opposite of the rest. You can apply a pan and tilt Invert by following the
settings in the table below.
F
UNCTION
S
ET
T
O
N
OTES
PAN
YES
Pan Invert
tiLt
YES
Tilt Invert
C o l o r W h e e l ( s p l i t c o l o r s )
Linear progression or advancement of the color wheel will enable you to stop anywhere in between
two adjacent colors.
two adjacent colors.
F
UNCTION
S
ET
T
O
N
OTES
COLI
YES
With linear progression or advancement of the
color wheel split colors will be achieved.
Service Functions
F i x t u r e R e s e t ( a l l m o t o r s )
This function will re-initialize the fixture by returning all motors to its startup positions or otherwise
known as (home position).
known as (home position).
F
UNCTION
S
ET
T
O
N
OTES
rESt
[ENTER] Reset fixture