Yamaha RX-Z11 Manual De Usuario

Use the supplied simplified remote control to make basic controls of this unit.

■ Setting the controlling zone of the simplified 

Use this feature to set the controlling zone (see page 139) and 
remote control ID (see page 143) of the simplified remote control.

Setting the remote control ID
Press and hold b on the simplified remote control and then 1 or 
2 for 3 seconds to select the desired remote control ID.
• ID1: Press and hold b and 1.
• ID2: Press and hold b and 2.

Setting the controlling zone
Press and hold a on the simplified remote control and then 1, 2, 
3, or 4 to select the desired zone.
• Main zone: Press and hold a and then press 1.
• Zone 2: Press and hold a and 2.
• Zone 3: Press and hold a and 3.
• Zone 4: Press and hold a and 4.

■ Replacing the battery in the simplified remote 

Change the battery when the operation range of the simplified 
remote control decreases.

• Insert the battery according to the polarity markings 

(+ and –).

• If the batteries run out, immediately remove them from the simplified 

remote control to prevent an explosion or acid leak.

• If a battery starts leaking, dispose of it immediately. Be careful not to let 

the leaking battery acid touch your skin or clothing.

• Before inserting new batteries, wipe the compartment clean.
• Dispose of batteries according to your regional regulations.

STANDBY
Sets the selected zone to the 
standby mode.

SYSTEM MEMORY
Save or recall the system settings.

INPUTl / h
Select the input source.

PRESET +/–
Recall the preset FM/AM, XM 
stations, or the network/USB 
contents.

☞   P. 70, 74, 84

s(stop) / p(play) / 
b(skip backward) / 
a(skip forward)
Control playback of the iPod or 
Network/USB contents.

POWER
Turn on the power.

VOLUME +/–
Adjust the volume level.

MUTE
Mutes the audio output.

Remove the insulation sheet before using the remote 
control.