CMA Dishmachines MODEL GL-C Manual De Usuario

                                                                                                                                                      

Operation

 

•  Ensure that the overflow drain tube is in place in the detergent tank. 
•  Flip power on-off/flush switch to the “ON” position. The water will fill until the proper level is 

reached then turn the heating element “ON”. 

•  The water temperature is controlled by a heater and a thermostat .The thermostat should be set  

for minimum 140

°F/60°C. 

•  Open the door; flip power on-off/flush switch to the “ON” position. Wash tank will automatically fill.  
•  Ensure there is product in the detergent, sanitizer and rinse agent containers. 
•  Detergent is fed from the supply container into the detergent tank in controlled amounts by the 

detergent pump. Use detergent at strength recommended by your chemical supplier. 

•  Load glasses on the conveyor. Start machine with GL-C rocker switch located on front right side of 

unit. Machine now will stop and start with conveyor shut-off rod. 

The amount of chemical delivered, whether it is detergent, sanitizer or rinse aid, can be obtained by counting 
the revolutions of the injector rotors. 

•  For detergent, contact your chemical supplier for proper type and detergent concentration. 

 Note:  Detergent pump only operates when hot water tank is filling.  

•  For sanitizer, one revolution in 5 seconds equals approximately 12.5ppm Iodine or 50ppm 

chlorine. 

•  For rinse agent, one revolution in 8 seconds is recommended. 

To Adjust Detergent Injector: 

•  When a new detergent container is installed, push the prime button in and hold until the detergent feed tube is 

full. 

•  Install the overflow drain tube and switch power on-off/flush switch to the “ON” position. The detergent feeder 

will now feed detergent into the detergent tank with water fill. 

•  To increase detergent volume, turn the detergent adjustment screw clockwise. 
•  To decrease the detergent volume, turn the detergent adjustment screw counter-clockwise. 

 To Adjust Sanitizer Injector: 

•  When a new sanitizer container is installed, push the prime button in and hold until sanitizer feed tube is full. 
•  Start the washer with rocker switch located on the front of the machine. Take a sample from the final rinse 

spray tube to check sanitizer level. 

•  To increase the volume of sanitizer, turn the adjustment screw clockwise. 
•  To decrease the volume of sanitizer, turn the adjustment screw counter-clockwise. 

Page