Beko RRN 2650 Manual De Usuario

The device should be transported only in  

upright position. 

The packing as supplied must be intact during 

transportation.

After a transport in the horizontal position, the 

device may only be taken into operation 4 

hours after being stood up vertically again.

The appliance must be protected against rain, 

moisture and other atmospheric influences.

The manufacturer assumes no liability if safety 

instructions are disregarded.

Make the device unusable immediately. Pull 

out the mains plug and cut the power cable. 

Remove or destroy snap or latch locks before 

disposing of the device. In this manner you 

prevent children from locking themselves in 

and endangering their lives.

•  Do not operate your appliance in a room 

where the temperature is likely to fall below 

10 °C at night and/or especially in winter. At 

lower temperatures the appliance may not 

operate, resulting in a reduction in the storage 

life of the food.

•  

The climate class rate of your appliance is 

given in Technical Features leaflet and written 

on the rating label inside the appliance. It 

specifies the appropriate operating ambient 

temperatures as explained below.

SN.......................+10 °C to 32 °C

N .........................+16 °C to 32 °C

ST .......................+18 °C to 38 °C

T..........................+18 °C to 43 °C

SN-ST .................+10 °C to 38 °C

SN-T ...................+10 °C to 43 °C

Only place the device in dry rooms which can 

be aired.

Avoid direct sunlight or direct heat sources 

such as a stove or a heater.

If this cannot be avoided, the following 

minimum distances should be maintained:

Electric stoves:

3,00 cm

Heater:            

3,00 cm

Cooling devices:  2,50 cm  

•  Ensure sufficient air circulation for your 

device.

• Make sure that sufficient room is provided 

around the appliance to ensure free air 

circulation.

Fit the two plastic wall spacers supplied with 

the appliance rotating 1/4 turn to the condenser 

at the back of the appliance (Fig. 3).

• The device should be located on a smooth 

surface. The two front feet can be adjusted as 

required. To ensure that your appliance is 

standing upright adjust the two front feet by 

turning clockwise or counter-clockwise, until 

the product is in firm contact with the floor. 

Correct adjustment of feet avoids excessive 

vibration and noise.

This device must be grounded.

• Check whether the power type and voltage 

in the device location corresponds to the one 

stated on the 

rating label

 inside the device.

 • The electrical safety of the device is only 

assured when the grounding system in the 

house is installed in accordance with 

regulations.

• When putting the device in, do not stand it 

on the power cable, otherwise the cable will 

be damaged.

• Take care to ensure that the plug remains 

readily accessible. Do not use multiple adapter 

bar or extension cable.

2