AEG CGA 60 WOK Manual De Usuario

Descargar
Página de 12
4
B - 
Cooking Instructions
Automatic start-up without valves
Turn the corresponding knob anti-clockwise up 
to the maximum position (large flame, Fig. 1) and 
press start-up button P(fig. 1).
Automatic start-up with valves
Turn the corresponding knob anticlockwise up 
to the maximum position (large flame, fig. 1) and 
press the knob.
Once the burner has been started up, keep the 
knob pressed for about 6 seconds.
Using the burners
In order to obtain the maximum yield without 
wasting gas, it is important that the diameter of 
the pot is suitable for the burner potential (see 
the following table). This is to avoid the flame 
extremities being larger than the base of the pot.
All of the operating positions must be chosen 
between the maximum and the minimum ones, 
never between the minimum position and the 
closing point.
The gas supply can be interrupted by turning the 
knob clockwise up to the closing position.
NOTE:
If there is no power supply, it is possible to light the 
burners with matches, setting the knob to the start-
up point (large flame, fig. 1).
BURNERS
POWER (MJ/h)
POWER (Btu/h)
Ø of pots
Auxiliary
3.2
3000
10 - 14 cm
Semi-rapid
6.3
6000
16 - 18 cm
Rapid
11.6
11000
20 - 22 cm
Wok
17.9
17000
24 - 26 cm
NOTE:
When the equipment is switch off, always check 
that the knobs are in the closing position.
If the flame should blow out accidentally, the 
safety valve will automatically stop the gas supply, 
after a few seconds. To restore operation, set the 
knob to the lighting point (large flame, fig. 1) and 
press. While cooking with fat or oil, pay the utmost 
attention as these substances can catch fire when 
overheated.
WARNING:
Do not use sprays near the appliance in operation.
Do not place unstable or deformed pots on the 
burner, so as to prevent them from overturning or 
overflowing.
Always turn gas off if moving a pot away from the 
appliance.