Cres Cor CO151HWUA5B Manual De Usuario

Ovens Humidity with 

Microprocessor Controls 

Rev. 8 (1/05) 

Page 

5 of 13

 

 

 

• Mentor, OH 44060-1833 

• 440/350-1100 

• www.crescor.com 

HOW TO SET THE CONTROL, continued 
FOR PROBE COOK OPERATION:  
Press the SELECT button to choose the probe 
mode.  
 
PROBE TEMPERATURE:  
1.  Press the PROBE/TIME button. The display 

will show the probe setpoint temperature.  

2.  Use the UP and DOWN arrows to set the 

desired temperature.  

3.  Press the SET button to enter the 

temperature into the control.  

NOTE: Press the OVEN TEMP button at any 
time to view the actual oven temperature. 
Press the START button and the display will 
show the actual probe temperature. 
NOTE: The control will beep when the probe 
setpoint temperature has been reached and then 
will automatically switch to HOLD mode. The 
display will then show the hold setpoint 
temperature.  
 
To manually end the COOK/RETHERM, 
PROBE, or HOLD mode:  
Press the STOP button during any of the above 
modes and the control will end that mode. If in 
the Cook/Retherm or Probe mode, the control 
will automatically switch into the HOLD mode. 
 
HOW TO OPERATE WITH FOOD:  
Manual (Timed mode) Operation 
See “HOW TO SET CONTROL” (on page 4) 
for programming instructions.  
1.  Push power switch to “ON”.  
2.  Press the SELECT button and choose the 

TIMED mode. 

3.  Press the COOK button and set to desired 

temperature. 

4.  Press the PROBE/TIME button and set to 

the desired time. 

5.  Press the HOLD button; set desired 

temperature.  

 

6.  Place the food into oven. Close door and 

double check cooking time and 
temperatures. Then press the START button 
to start the cooking/retherm cycle and the 
Cook LED will light up.  

7.  The oven will beep and automatically switch 

to the HOLD mode at the end of the cooking 
cycle. The Cook lamp will go out and the 
Hold lamp will light up.  

Probe Cooking 
See “HOW TO SET CONTROL” (on page 5) 
for programming instructions. 

1.  Push power switch to “ON”.  
2.  Press the SELECT button and choose the 

Probe mode. 

3.  Insert the probe jack into the receptacle 

located inside the oven top, near the 
fans. The probe temperature display will 
show the digital temperature of the 
probe. 

4.  Put sanitized probe into center of food 

product. Make sure food is in the center 
of the pan and the pan is centered in the 
oven.  

5.  Press the start button. The cook lamp 

will light up and the display will show 
the internal temperature of the food 
being cooked.  

 
 
NOTE: Do NOT change the mode of the 
controls (probe or timed) while oven is 
operating in a Cook/Retherm cycle. Oven must 
be in the HOLD cycle to change the timer or 
probe operation.