Cornelius Universal C-750 Manual De Usuario
2
185211001
NOTE: Only qualified personnel should install this kit.
1. Unpack loose–shipped parts. Make sure all parts are present and in good condition.
Table 1. Loose-Shipped Parts
Item
No.
Part No.
Name
Qty.
1
200468012
Sheet Metal Screw, Phil Truss Hd, No. 8 by 3/4-in.
12
2
308981044
Front Cover Plate
1
3
308982044
Back Cover Plate
1
4
313093000
Plug, 2-in.
1
5
172127000
Plug
1
6
960265000
Permagum Sealer,12-in. long
1
8
960115000
Rubatex Insulation,1/8 by 1/2-in. (78-in. long)
1
INSTALLING WATER TANK SEAL KIT
IMPORTANT: This kit is intended to seal the water tank to prevent leakage from splashing water when
moving or transporting the Dispenser. IT IS NOT INTENDED THAT THE DISPENSER MAY BE LAID ON
IT’S SIDE WHEN WATER TANK IS FULL OF WATER.
moving or transporting the Dispenser. IT IS NOT INTENDED THAT THE DISPENSER MAY BE LAID ON
IT’S SIDE WHEN WATER TANK IS FULL OF WATER.
1. If Dispenser is in operation, place power switch on back of Dispenser in ‘‘OFF’’ position.
2. Remove four screws securing Dispenser top cover, then lift cover straight up and off.
NOTE: Front of Dispenser is the side facing the dispensing valves.
3. Place RUBATEX INSULATION (item NO TAG) all the way around outer edges of FRONT COVER PLATE
(item 2) and BACK COVER PLATE (item 3) as shown in illustration. FILL ANY GAPS AT BUTT EDGES
OF RUBATEX INSULATION WITH SMALL PIECES OF PERMAGUM SEALER (item 6).
OF RUBATEX INSULATION WITH SMALL PIECES OF PERMAGUM SEALER (item 6).
4. Place FRONT COVER PLATE (item 2) in position on top of water tank as shown in illustration. IT MAY BE
NECESSARY TO VERY CAREFULLY REFORM OR REPOSITION INSULATED REFRIGERATION LINE
ANGLE TO FIT INTO CUTOUT AREA IN CORNER OF FRONT COVER PLATE.
ANGLE TO FIT INTO CUTOUT AREA IN CORNER OF FRONT COVER PLATE.
5. Secure back side of front cover plate to agitator motor support plate with four THREAD CUTTING
SCREWS (item NO TAG).
6. Secure rest of front cover plate to plastic motor tank rim with six SHEET METAL SCREWS (item 1). DO
NOT OVERTIGHTEN SCREWS INTO PLASTIC.
7. Place BACK COVER PLATE (item 3) in position on top of water tank as shown in illustration.
8. Secure front side of back cover plate to agitator motor support plate with four THREAD CUTTING
SCREWS (item NO TAG).
9. Secure rest of back cover plate to plastic water tank rim with five SHEET METAL SCREWS (item 1). DO
NOT OVERTIGHTEN SCREWS INTO PLASTIC.
10. Place PLUG (item 4) in agitator motor plate water fill hole.