Cornelius Universal 750 Prospecto

569000320

May 23, 2000

IMI Cornelius Inc; 2000

IMI CORNELIUS INC

One Cornelius Place

Anoka, MN 55303-6234

Telephone (800) 238-3600 Facsimile (763) 422-3246

INSTALLATION INSTRUCTIONS

CONDENSER FAN MOTOR ASS’Y REPLACEMENT KIT

(P/N 569000321 and 569000322)

UN 750 PRE–MIX DISPENSER

Read and understand these instructions thoroughly before installing this kit. Retain these instructions as part of
your equipment manual.

NOTE: Only qualified personnel should install this Kit.

Table 1. Loose-Shipped Parts

Item

No.

Part No.

Name

Qty.

569000321
569000322

Condenser Fan Motor Ass’y Kit (120 VAC, 60 Hz, 16 Watts, 1400 RPM)
Condenser Fan Motor Ass’y Kit (230 VAC, 50/60 Hz, 16 Watts, 1200 RPM

1
1

569000320

Installation Instructions

690945000

WireTie

WARNING: To avoid possible fatal electrical shock or serious injury to Installer, make sure
Dispenser is disconnected from power source before attempting to install this kit.

1. Disconnect electrical power from the Unit.

2. Remove screw securing back and right side grills on the Dispenser, then remove grills.

3. Disconnect condenser fan motor assembly power cord connector from the Dispenser wiring harness con-

nector.

4. Remove four screws securing the condenser fan motor assembly to the refrigeration deck. Remove old

condenser fan motor assembly from the Dispenser.

5. Remove bolt securing the condenser fan blade to the old condenser fan motor shaft, then remove the fan

blade. Discard the old condenser fan motor assembly.

6. Install the condenser fan on the new CONDENSER FAN MOTOR ASS’Y (item 1) shaft and secure with

screw and washer provided with the new condenser fan motor assembly.

7. Install the new condenser fan motor assembly on the Dispenser and secure with four screws.

8. Connect new condenser fan motor assembly power cord connector to mating electrical connector on the

Dispenser wiring harness where the old condenser fan motor assembly was disconnected in step 3.