Bunn ULTRA-2 PAFA Manual De Usuario

2. Depress the hopper lock

plunger, lift slightly.

DISASSEMBLY & CLEANING

Turn cooling to OFF selection. Empty all product from the hopper(s). Turn auger to OFF selection.

4.Pull the auger from the cool-

ing drum.

6. CAUTION: Faucet valve is

under spring tension. Spread

one side of the handle first, then

the other and disconnect from

hopper.

8. Remove the auger nose bush-

ing from inside the front of the

hopper. NOTE: Do not scratch

this surface when cleaning. Deep

scratches could cause leakage

around the seal.

5. Remove the hopper seal from

the flange on the cooling drum.

3. Pull the hopper assembly

forward and remove.

9. Remove the drip tray and

cover.

7. Carefully slide valve up to

remove spring and faucet seal.

Extra care should be taken when

handling the seal to prevent

damage.

10. Place all parts in a clean sink with mild hot water (120°F) and sanitizer solution. Allow all parts

to soak for at least 5 minutes. Carefully wash all components with a clean wash cloth in the hot

water and sanitizer solution. Use a clean, soft bristle brush as needed for the smaller components

and tight areas. Do not immerse hopper lids. Use a commercial sanitizer that has 100 ppm of

available chlorine with a concentration level of at least 3% available chlorine (KAY-5 Sanitizer).

Follow the sanitizer’s mixing instructions to ensure 100 ppm of available chlorine.

11. Wash the drum(s), hopper drip tray(s), top cover(s), and outer enclosure using a clean wash

cloth that has been dampened in the hot water and sanitizer solution. Pay particular attention

to the shaft area and make sure it is thoroughly cleaned and sanitized.

12. Thoroughly rinse all surfaces with a clean wash cloth that has been dampened with hot water.

Wipe dry with a clean dry wash cloth before reassembling the dispenser.

NOTE – Although most parts are dishwasher safe, they may be affected by the chemicals in some

commercial sanitizing agents. Do not place the hopper nor hopper lids in a dishwasher. Rinse thor-

oughly before assembly.

1. Slide PAF assembly back

until it latches before removing

ULTRA Hoppers.

43553 071410