Bunn U3/SRU Manual De Usuario

Descargar
Página de 9
Page 5
ELECTRICAL INSTALLATION INSTRUCTIONS - ALL MODELS
NOTE: Electrical source should have a circuit breaker between the brewer and the main supply which breaks all 
poles with a contact separation of at least 3 mm.
CAUTION – Improper electrical installation will damage electronic components.
1.  An electrician must provide electrical service as specified.
2.  Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.
3.  Before electrically connecting the brewer, remove the front cupola cover (some models have the thermostat 
knob on the outside of the cover) and rotate the thermostat knob fully counterclockwise to the "OFF" position. 
Keep this knob in the "OFF" position until performing the Initial Setup.
4.  Electrical service is connected at the upper rear of the single service and scrambler brewers using a junc-
tion box. On double service brewers the rear decorative channel must be removed for access to the terminal 
block.
5.  Connect the brewer to the power source and verify the voltage at the terminal block before proceeding.   Re-
place all panels.
6.  If plumbing is to be hooked up later be sure the brewer is disconnected from the power source.  If plumbing 
has been hooked up, the brewer is ready for Initial Setup.
SRUA-CE Models require 2-wire, 
grounded service rated 230 volts ac, 
30 amp, single phase, 50 Hz.
P1842
  SRU  Models  require  2-wire, 
grounded service rated 208 or 240 volts 
ac, 30 amp, single phase, 60 Hz.
GREEN
GREEN
230V A.C.
RED
BLACK
P1842
L1
L2
GREEN
GREEN
RED
BLACK
L1
L2
208 OR 
240V A.C.
ELECTRICAL REQUIREMENTS - SRU, SRUA
CAUTION - The brewer must be disconnected from the power source until specified in Initial Set-Up.
CE REQUIREMENTS
• This appliance must be installed in locations where it can be overseen by trained personnel.
• For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.
• Appliance shall not be tilted more than 10° for safe operation.
• An electrician must provide electrical service as specified in conformance with all local and national codes.
• This appliance must not be cleaned by water jet.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental 
capabilities, or lack of experience and knowledge, unless they have been given instructions concerning use of 
this appliance by a person responsible for its safety.
• Children should be supervised to ensure they do not play with the appliance.
• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel with 
a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.
42769  012610