Frigidaire FFWC38F6LS Manual De Usuario

4



The exterior walls of the wine cooler may become quite 

warm as the compressor works to transfer heat from 

the inside.  Temperatures as much as 30° F warmer 

than room temperature can be expected.  For this 

reason it is particularly important in hotter climates to 

allow enough space for air circulation around your wine 

cooler.

The wine cooler must have all bottom corners resting 

firmly on  solid floor. The floor must be strong enough 

to support a fully loaded wine cooler. NOTE:  It is Very 

Important for your wine cooler to be level in order to 

function properly.  If the wine cooler is not leveled during 

installation, the door may be misaligned and not close 

or seal properly, causing cooling, frost, or moisture 

problems.    

After removing all interior and exterior packaging 

materials, use a carpenter’s level to level the wine cooler 

from front-to-back. Adjust the leveling legs in front, ½ 

bubble higher, so that the door closes easily when left 
halfway open.

Wash any removable parts of the wine cooler interior,  

and exterior with mild detergent and warm water. 

Wipe dry. Do not use harsh cleaners on these 

surfaces.
Do not use razor blades or other sharp instruments,  

which can scratch the appliance surface when 

removing adhesive labels. Any glue left from the tape 

can be removed with a mixture of warm water and 

mild detergent, or touch the residue with the sticky 

side of tape already removed. Do not remove the 

serial plate.

Important Safeguards: Do not store food in your wine 

cooler as interior temperature may not get cool enough 

to prevent spoilage. In summer months or areas of high 

humidity,  the glass door may build up moisture.  To 

remove the moisture,  wipe it away.

Set handle over the two mounting studs at top of 

door.
Use hex head screw driver or allen wrench to tighten 

set screws from bottom to secure handle to door.

� Handle 

ĸ

 Wooden Shelf Made of Beech 

Ĺ

  Control Panel 

� Glass Door 
� Control Switch of Lamp 
� Adjustable Leg 

 

The wine cooler should be placed in dry and ventilated room. The location of 
the wine cooler should not be irradiated by direct sunshine. The wine cooler 
should be far away from heating sources, such as: cooking stove or heating 
radiator. If the wine cooler has to be placed near heating source, please adopt 
proper heating insulation board for insulation or keep the wine cooler at least 
the following minimum distances away from the heating sources: 
For electric stove: 3 ΁.   
For oil or coal stove: 30 ΁.   

The door hinges of this wine cooler can be interchanged between the left and 

right sides. 

1. Set the handle on the fixation shaft. 

 

 

Fixation Shaft of Handle 

 

Set Handle 

 

2. Screw down the fixation pins of the handle with screw driver. 

- 7 - 

Mounting stud

Locate handle

Screw driver

 

Handle Fixation Pin 

Screw Driver 

Place the wine cooler on the planned location and level it. 

The front screw of leg is adjustable. 

 

 

The climate type is marked on the model nameplate. It indicates the room 

temperature range for operation of wine cooler. 
 
Climate Type   

 

 

Indoor Temperature Range 

 
N   

 

 

 

 

 

+16°C to 32°C 

 
ST   

 

 

 

 

 

+18°C to 38°C 

 
T   

 

 

 

 

 

+18°C to 43°C 

 
 
 

- 8 - 

Set screw

This Use & Care Guide provides general operating 

instructions for your model. Use the appliance only as 

instructed in this Use & Care Guide. Before starting the 

  Choose a place that is near a grounded electrical 

• 

outlet. Do Not use an extension cord or an adapter 

plug.

  For optimal performance, it is recommended that 

• 

you install the wine cooler where the ambient 

temperature is between 70 and 78 degrees 

fahrenheit. 

  Allow space around the unit for good air circulation.  

• 

Leave a 2 inch space on the back and sides of the    

wine cooler for adequate circulation. 

  Be sure the wine cooler stays in the upright position  

• 

during transport.

  Keep the wine cooler from any hazardous or 

• 

combustible agents.